جدید پروگرامر ST Link V2 JTAG

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module and JTAG/serial wire debugging interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. STM8 applications use the USB full speed interface to communicate with STMicroelectronics' ST Visual Develop or ST Visual Program software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

:Features

5V power supplied by a USB connector

USB 2.0 full speed compatible interface

USB standard A to mini B cable

Programming:Programs FLASH ROM, EEPROM, AFR, Security-bits, etc.

Operating temperature 0 to 50°C

:SWIM specific features

1.65V to 5.5V application voltage supported on SWIM interface

SWIM low-speed and high-speed modes supported

SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed

SWIM cable for connection to the application via an ERNI standard vertical or horizontal connector

SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector

:JTAG specific features

1.65V to 3.6V application voltage supported on the JTAG interface and 5 V tolerant inputs

JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector

Direct firmware update feature supported

Status LED which blinks during communication with the PC

:Supported Devices

Supports all STM8 MCU interfaces with SWIM

Supports all STM32 family of microcontrollers with JTAG / SWD interface

:ST-LINK/V2 Status

The LED labeled 'COM' on top of the ST-LINK/V2 shows the ST-LINK/V2 status (whatever the connection type). When the:

LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found

LED is RED: communication between ST-LINK/V2 and the PC is established , end of enumeration

LED is blinking GREEN/RED: data are being exchanged between the target and the PC

LED is GREEN: the last communication has been successful

LED is ORANGE: ST-LINK/V2 communication with the target has failed


نوشتن نظر

لطفا برای ثبت نظر وارد حساب خود شده یا ثبت نام نمایید.

پروگرامر ST Link V2 JTAG

  • مدل کالا: 1900331
  • موجودی: در انبار
  • 100,000 تومان

برچسب ها: پروگرامر stlink, پروگرامر st link, پروگرامر st link jtag, پروگرامر jtag, قیمت stlink, قیمت stlink v2, قیمت stlink jtag, فروش stlink, فروش st link, فروش stlink jtag, فروش stlink programmer, پروگرامر ST Link V2 JTAG, پروگرامر st link v2

کالا در حال حاضر موجود نمیباشد.ایمیل خود را وارد نمایید، زمانی که کالا در دسترس باشد به شما اطلاع میدهیم.